Castelle Office Direct OfficeDirect Storage Server Installation Manual download pdf (Page 256)

18 - 2 Sage Intergy 7.00 Install Guide Sage

Appendix G: Cardio Service Installation

Overview

The Cardio service is a Sage Intergy service that is normally installed when IEHR is

configured to receive patient data from a Heart Centrix ECG device. This service provides a

web authentication component on a custom TCP port. To support operation of the ECG

hardware, the Heart Centrix server and client components must also be installed in the

customer environment. Typically, this installation is performed by employees of the Cardiac

Science Corporation and not by Sage technicians. Cardiac Science personnel are also

responsible for installation of Heart Centrix client components on each Sage Integy client

workstation or terminal server.

In a typical installation, the Heart Centrix software is installed on a server that is not also a

Sage Intergy database server or application server. In most cases, this server will be

purchased from Sage and installed in the customer environment by Sage technicians, who

will be required to install and to configure both the hardware and the operating system. Sage

technicians will also be responsible for gathering specific data required for successful

connectivity between IEHR and the Heart Centrix server. These installation requirements are

described in more detail below.

Additional configuration on both the Sage Intergy system and the Heart Centrix server are

required when the Cardio service is installed for use with Sage Intergy on Demand. For this

type of installation only, refer to the configuration steps beginning on page 18-5.

Sage Intergy server installation steps

Network Configuration

Heart Centrix application services must make specific network connections via the numeric

IP address. For this reason, Sage R&D strongly recommends that the Sage Intergy database

server be configured with a static IP address, or with a DHCP reservation when the Cardio

service is installed.

Sage Intergy Services selection

The Heart Centrix server software connects to IEHR through the Cardio service. For new

implementations of Sage Intergy, this service is selected from the Sage Intergy Services

installation window during initial installation of the database server.

For installation that occurs when upgrading to Sage Intergy 7.00, or when adding the Cardio

service to an existing Sage Intergy 7.00 server, you will instead use the ‘IntergyCardioSvc.bat’

1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 283 284

No comments

Castelle Office Direct OfficeDirect Storage Server Installation Manual Page 256