Castelle FaxPress Specifications Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 674
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
Installing FaxPress Server Hardware Installing the Server
2—3
Installing FaxPress Server Hardware
Each FaxPress server contains all of the hardware required to concentrate network
faxing into a single location:
10/100BASE-T network interface connections
14.4k bps fax modem with configurable fax line connections
Intelligent microprocessor
Serial and parallel printer ports
Attaching the FaxPress Server to your Network
To attach the FaxPress server to your network, follow these steps:
1. Connect the network cable to the FaxPress server. FaxPress Ethernet servers
use an RJ-45 connector for 100BASE-T topology.
Note: If you are installing the FaxPress server in an NT environment, you
must assign the FaxPress a unique IP address. To configure the
FaxPress with an IP address, place the unit on the same network
segment as the configuring workstation. The installation program
allows you to assign the FaxPress server an IP address. If you want
the FaxPress on a different segment, install the software first, then
use the FaxPress
Administrative Tools
to configure the FaxPress
with an IP address for the segment you want to move the unit to.
Refer to
"Administrator Utilities" on page 6-3
, for instructions on
changing the FaxPress’ IP address.
2. Connect the fax lines to the FaxPress server.
3. If you are connecting a printer to the FaxPress server, connect the printer
cable to the appropriate printer port.
4. Plug the power cable into the FaxPress server.
5. Plug the power cable into a power source. On 5000 and 7000 units, set the
power switch to ON.
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 673 674

Comments to this Manuals

No comments