Castelle FaxPress Specifications Page 614

  • Download
  • Add to my manuals
  • Print
  • Page
    / 674
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 613
FaxPress Guide
B—2
Online Troubleshooting Help
FaxPress troubleshooting help is also available on Castelle’s web site.
Vist Castelle Technical Support’s tech notes and Frequently Asked Questions at:
http://www.castelle.com/support/documentation/tech.htm
and:
http://www.castelle.com/support/documentation/faq.htm
Powering Up the FaxPress
When you connect the new FaxPress to the network and power the unit on, the red
and green LEDs on the front panel flash for 15 to 30 seconds during the boot cycle.
The red LED stays on after the boot cycle completes. This indicates that it has
powered up successfully. If the LED marked “10BT” or the LED marked
“100BT” turns on, it indicates that the unit is connected to the network. You
should also see the appropriate green light on the hub.
Changing the FaxPress Fuse
For SBE, 2500, 5000, 7000 and 7500 units.
Warning: Disconnect the power cable before you remove the fuse holder in the
power switch
To check and replace the fuse:
1. Switch-off the FaxPress SBE, 2500, 5000, 7000 or 7500 power switch and
remove the power cord.
2. Locate the fuse housing between the power cable connector and the switch.
Use a flat blade screwdriver or similar device to pry the housing out.
Page view 613
1 2 ... 609 610 611 612 613 614 615 616 617 618 619 ... 673 674

Comments to this Manuals

No comments